How to make a three wheel drifting motorcycle

How to make a three wheel drifting motorcycle


hi there .. in a previous video i showed you how to make a very simple mini electric car that can only goes forward so today based on the same idea we’re gonna be making a three wheel motorcyle that not only goes forward but it can also drifts and breaks we will need a few materials that you need to get first starting by taking two bottle caps and you will notice that there is a tiny spot at the middle you can use that as a mark to burn a hole exactly into the center using a Soldering iron if you don’t have one a nail and a hammer will work as well after drilling each cap gule both caps together then remove any excess glue on the outside now you have the first wheel take another two caps an repeat the same steps you did for the first two caps until you end up with two wheels like those next .. take one lollipop stick and pass it through one wheel then glue it in place now take a drinking straw and cut a 3 cm piece slide the straw onto the stick then put the other wheel and glue it in place this is gonna be the front wheels now take a 9 v battery and glue the front wheels here at the edge the next step is to make the back wheel which consist of a dc motor and a bottle cap the dc motor and the plastic piece can be found in cassette players and cd players but it can also be found at any electronics repair store where these clips can be found as well after you get them glue the motor to the bottle cap and make sure that the plastic piece is perfectly settled at the center now if we connect the moto to the battery the cap will start rotating forming the engine of the motorcycle the next step is to connect the front wheels and the back wheel for that we’re gonna use a lollipop stick and a piece of a hard cable which you can find at any electrical supply store to make the connection we’re gonna cut 15 cm of the wire and start curling it around the lollipop stick after that pull the wire out and put some glue inside then hold it in place make sure that half of the wire is outside the stick and i’ll tell u why in a moment now put some glue at the positive side of the battery then hold the stick in place when the glue dries out take the flexable part of the wire and glue it to the motor it’s time now for testing it so connected the motor to the battery and once yoy put it on the ground it will start moving forward for more excitment bend the curled wire to either direction and it will start moving in a circular motion and the more you bend the wheel the crazier it goes and for more stable performance i recommend that you put a small rubber band around the cap because it makes it more steady on the ground finally let’s make the handlebar by taking the last lollipop stick and the remainings of the hard cable and start curling it exactly the same as we did before after that bend down the sides out of the stick forming this shape using a lighter start shaping the handlebar the same way as i do here now glue it at the front like that now we’re done but one final thing if you’re concerned about replacing the battery you can just use a rechargable one so you don’t have to replace it

22 comments

Add a Comment

Your email address will not be published. Required fields are marked *